standard pressure
英 [ˈstændəd ˈpreʃə(r)]
美 [ˈstændərd ˈpreʃər]
网络 标准气压; 标准压力; 标准大气压; 標準壓力
英英释义
noun
- a unit of pressure: the pressure that will support a column of mercury 760 mm high at sea level and 0 degrees centigrade
双语例句
- The Further Improvement of Some Problems for National Safety Assessment Standard of Pressure Vessel Containing Defects
进一步完善我国含缺陷压力容器安全评定标准的若干问题 - The problems in present assessment of the pressure temperature coefficient were pointed out, the variation law of the pressure temperature coefficient was systemically analyzed, and the method in calculating standard pressure coefficient was also established.
提出了目前评价压强温度系数所存在的问题，较系统地分析了压强温度系数的变化规律，建立了参比压强温度系数的计算方法。 - Establishes an empirical formula relating temperature to saturated humidity ratio under standard atmospheric pressure by means of polynomial regression. Analyzes the calculating error in common engineering temperature range, and the error is less than 2.1 percent.
利用多项式回归拟合了标准大气压下温度与饱和含湿量之间的经验公式，并进行误差分析，认为在工程常用温度范围内，计算误差小于2.1%。 - Under the assumption of the mathematical models of the pseudo steady state and unsteady state flow, and equation of meeting the needs of the standard pressure in coalbed gas may be obtained by use of the standard gas pressure to replace the pressure in Langmuir adsorption formula.
在拟稳态流和不稳态流的数学模型假设下，用气体标准压力代替Langmuir吸附公式中的压力，得到气层中标准压力所满足的方程。 - Bronze& One of the first alloys developed in the bronze age is generally accepted as the industry standard for pressure rated bronze valves and fittings.
青铜是人类在青铜时代发展的最早的合金之一，通常作为压力等级青铜阀门和配件的工业标准使用。 - By converting test condition to the standard pressure condition, calculation accuracy of average pressure impulse coefficient method is superior to that of tangent method.
换算到标准压强条件下，平均压强冲量系数法的计算精度优于切线法的计算精度，并作出了计算验证。 - Ten liters of gas at standard pressure and temperature contains about 2 ×?? toms.
10公升的气体，在标准压力和温度下含有大约2×？指鲈0子。 - The flash point test result is automatically corrected to standard pressure ( 101.3 kPa).
闪点测试结果会自动更正为标准压力（101.3千帕）。 - This paper from the working principle of static expansion method, pointed out the exist problem of the original device, redesigned the major parts and put forward a new way to test the preceding standard pressure.
从静态膨胀法的工作原理出发，指出原膨胀法测压装置存在的问题，对一些主要部件进行重新设计，提出前级标准压力测定新方法。 - Introduce a new method of determinating the standard of pressure test.
推荐一种确定新的压力试验标准的方法。